5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates

5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates
5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates

5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates

USED - Well taken care of. 5 count SmallRig Quick Release Clamps (Arca-type Compatible). 6 count Unbranded Quick Release Arca Plates 4 long plates, 2 medium plates. See below for more info. Note on the unbranded Arca plates.

Each of the four long plates are 150mm (49mm x 150mm x 9mm). However, the ONE plate with the red piece of tape pictured above is a bit wider than was advertised (51mm).

If that plate is to be used, the clamp has to be loosened a bit using a provided hex tool. It's an extra plate, so it shouldn't be an issue anyway. The following has nothing to do with the fact that the clamps are used. I bought them new and I had the following challenge which was not advertised.

Opening and closing the levers on the clamps loosens the hex screw over time and thus makes the plates easy to slide forward and back even though the clamp lever is'locked'. There's a safety mechanism - the two tiny screws underneath the plates and on opposite ends of each other - to avoid the plate slipping off the clamp entirely. The safety mechanism saved my camera on occasion. You can always fix the clamp by using the provided hex tool to slightly tighten the screw on the clamp when it loosens over time. I did this over the course of owning these and they worked like new each time they were tightened.

SmallRig Quick Release Clamp (Arca-type Compatible) 2143. Multiple 1/4''-20, 3/8''-16 threaded holes and thorough mounting holes. The Lever-type base for quick release. Is a lever-type base, tightness of which can be adjusted by stirring the tiny screw on the lever, so it is cross-compatible with most Arca type plates. It features multiple 1/4''-20, 3/8''-16 threaded holes and thorough mounting holes on the bottom, so you could mount it on tripods, jibs, and other devices.

Product Dimensions: 72 x 70 x 14mm. This item is in the category "Cameras & Photo\Tripods & Supports\Other Tripods & Supports".

The seller is "ed_742643" and is located in this country: US. This item can be shipped to United States.


5 count SmallRig Quick Release Clamp (Arca-type Compatible) with 6 Arca Plates


Homepage    Links    Contact Us    Privacy Policy    Terms of Use